Cirronet ZN-241GU Guía de usuario

ZN-241GI 802.15.4 Radio User’s Guide 3079 Premiere Pkwy, Ste. 140 Duluth, Georgia 30097 www.cirronet.com +1 678 684-2000

Select Comm Port Settings Click on Connect and the Select Comm Port Settings dialog will display as shown below. The “OK” after COM1 in the dialog bel

The first is to use the drop down menus to change the default settings for Comm Port, Baud Rate, Parity and Stop Bits to the correct values. Obviously

Configuration Fields The following table is a description of the Configuration Fields grouped into the three sections (Network Settings, Radio Comm Se

The four other fields under Network Settings are described below. Device Mode This is how a radio is set to be a Base or a Remote radio when either P

The Radio Comm Settings change the serial port settings on the ZN-241G. The dialog box that opens when you first start ZNWizard changes the settings f

Advanced Setup The ZN-241G is a very capable and flexible radio. The features and functions described in this manual, while sufficient for most applic

Warranty Seller warrants solely to Buyer that the goods delivered hereunder shall be free from defects in materials and workmanship, when given normal

Important Regulatory Information Cirronet Product FCC ID: HSW-ZN241 IC 4492A-ZN241 Note: This unit has been tested and found to comply with t

Getting Started The ZN-241G Starter Kit contains all of the items listed below. Before starting, identify each of the items in your kit. o ZN-241GI R

Attaching the Antenna The ZN-241GI radio is supplied with a foldable antenna with a screw type connector. Attach the antenna to the ZN-241GI by thread

Installing the Loop-Back Jumper To run the communications test, it is necessary to install the Loop-Back jumper between pins 5 and 6 on one of the ZN-

Connecting the ZN-241GI to a Computer The ZN-241GI is designed to connect to the serial port of a personal computer or an industrial device with eithe

Connect the wall-mount end of the power supply to a wall outlet with either 110VAC or 220VAC. The Power LED on the ZN-241GI will come on and after a m

When you click OK, a window will open up labeled COM1 Properties (or whatever COM port you selected) with a tab labeled Port Settings as shown below.

Verify the Link LEDs on both ZN-241Gs are on steady. Type characters on the computer keyboard and verify they are displayed on the screen as shown bel