Cirronet CR-SEB/X Manual de usuario descargar pdf (Pagina 7)

CR-SEB

Getting Started

The CR-SEB family of wireless Ethernet modems is easy to install and operate. In most instances, the

only installation steps will be setting IP addresses, configuring one CR-SEB as the master and connecting

the antenna, power and Ethernet cable. While the operation of the CR-SEB and CR-SEBX is the same,

the installation and connection is slightly different. Please refer to the appropriate section below for

connection and installation of your product.

Setting up a pair of CR-SEBs requires the following steps:

• Enter IP addresses into each CR-SEB

• Configure one CR-SEB as the Master

The default settings in the CR-SEBs are sufficient to allow connection to Ethernet networks and to have

the slave CR-SEB connect with the master. Other steps you may want to take include:

• Enter a default route IP address if data is to be sent off the CR-SEB’s subnetwork (See

Ethernet

Commands

)

• Enable one or more of the security features of the CR-SEB (See

Security Commands)

• Adjust the RF bandwidth allocation (See

Radio Commands)

• Filter out broadcast and multicast packets (See

Bridge Commands)

• Change the network number (

See Radio Commands)

Instructions on setting up the CR-SEBs are detailed in the

Configuring the CR-SEB section of this

manual. Details on the various operating modes and configurations can be found the

CR-SEB Operation

section.

 2000- 2004 Cirronet Inc 1 M-2410-0025 Rev A

1 2 3 4 5 6 7 8 9 10 11 12 ... 33 34

Sin comentarios

Cirronet CR-SEB/X Manual de usuario Pagina 7