Cirronet HN 210X Guía de usuario descargar pdf (Pagina 33)

HN-2010

Set Data Rate Divisor

Sets the serial bit rate between the modem and the host. This command takes effect

immediately and will require adjusting the host serial rate to agree. Nonstandard rates

may be programmed by entering a data rate divisor computed with the following

formula:

DIVISOR = (230400/RATE)-1

Round all non-integer values down.

Set Protocol Mode

Enables the base station to operate in a multipoint network. Depending on the user

application, more or less acknowledgment may be desired by the application.

Remotes can operate in transparent mode even though the base station is operating in

one of the nontransparent modes.

When using a protocol mode, make sure to count in packet overhead when calculating

network performance. Refer to the section on Protocol Modes for details on each

format.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Sin comentarios

Cirronet HN 210X Guía de usuario Pagina 33